Headphones Station
Hardware Installation
- install the Headphones Station on the left or right front leg of the pinball machine
- attach the wiring under the cabinet
- run it behind then inside the backbox
- plug the wiring to the PinSound+ board

Specific hardware installation
On a Data East or System11 pinball machine, you must disconnect the CN3 connector from the PinSound board.
On a System11 pinball machine, you must disconnect the J2 connector from the PinSound board.
The Headphones Station will now act as the main volume control.
With a PinSound 1 board, you need to connect the extra adapter to “J2”.
Then connect the audio cable to “Headphones Linout”.
The Headphones Station is compatible with any standard pinball leg bolts spacing.
Installing the Headphones Station adds about 6mm (less that 1/4″) thickness. (No extra long bolts are required)
How to use
Mute speakers
Speakers can be muted when headphones are connected, with the switch “mute” is ON
Change sound pagckage
(multiple sound package need to be present on the flash drive)
PinSound+ : you can change your sound package on-the-fly (if you have at least 2 different sound packages on the flash drive) by double turning (double tap) to the minimum (on the left) the Headphones Station knob
PinSound 1 : you can change your sound package on-the-fly (if you have at least 2 different sound packages on the flash drive) by turning to the minimum (on the left) the Headphones Station knob


Can't find what you are looking for?
If you can’t find the answer you’re looking for, ask a new question here.