Stern
Sound Board
Sound System
Shaker Motor
Original Parts
en_US
en_US fr_FR de_DE

ELIODOT

How can we help you?

Installation

  • Turn off your pinball machine.
  • Open the backbox and fold down the speaker panel.
  • Disconnect original DMD: 1 ribbon cable, 1 power supply cable.
  • Remove the original DMD: 4 or 6 screws.
  • Fit and connect ELIODOT.
  • Set the voltage selector switch to match the used power supply connector (low or high voltage) ⚠️ do not move this switch under power!
  • Close backbox and turn on the machine.
  • Adjust display brightness using the side button.

FAQ

  • Single press the side button to check current level.

  • Press repeatedly to reach the desired brightness.

Note: Brightness setting persists after power-off.

  1. Press and hold the side button for 3 seconds to enter the diagnostic menu.

  2. Short click to navigate to Startup Logo 

  3. Double-click the button to toggle ON or OFF.

  4. Hold button 3 seconds to save or wait for auto save & exit.

  1. Press and hold the side button for 3 seconds to open the menu.

  2. Short click to navigate to Antiflicker.

  3. Double-click to change ON or OFF.

  4. Hold button 3 seconds to save or wait for auto save & exit.

 Animated GIF of the antiflicker in action.

Note: The Antiflicker feature is only available on WPC games. It will automatically be enabled, but can be manually forced OFF in the menu settings if needed.

(not yet available, more info when optional hardware available)

  • FE1: 3 A Fast

  • FE2: 500 mA Fast

You can replace your ColorDMD and use the existing ColorDMD wiring harness to power your ELIODOT.

Don’t forget to set the voltage selector to ‘Low Voltage’ (the machine must be turned off before operating this switch).

ELIODOT

Universal DMD Led Display

Get yours now!